Catalog # 58642 (non-Pairable) & 58708 (Pairable)

​

• (2) One-Over-One Units that allow (center) Horizontal and Vertical Pairing, Units welded together for stability on one Caster Base Frame.

• Overall height of rack is 82-3/4”.

• Overall width is ~64” when welded together.

• Cages have 4.5 sq. ft. of floor area based on outside of frame dim. of 30” wide x 24” deep.

• Interior height of each cage is ~32”.

• Rack is supported on Colson Casters with 5” Dia. X 2” wide wheels, SS bearings. Front casters have Brakes.

• All metal components are #304 stainless steel.

• SS Spring Loaded Latches and pad lock tabs provided and on Divider Pulls Handles.

• Doors are constructed of ½” diameter rod with horizontal rods spaced ~1” or more apart.

• Feed Box and Foraging Board provided. 

• Horizontal Sliding Animal Door with multiple notches to open, on Front Hinged Door.

• The primary frame members are fabricated of 1/8” thick SS plate.

• All cage sides are fabricated of solid 16 Ga. SS sheet metal.

• Waste pans and troughs are fabricated of 16 Ga. SS sheet.

• The caster base frame is fabricated of 1-1/2” square SS tube.

• Wire Mesh Floors and rear of cage is 1” x 2” wire configuration.

• Heavy Duty Auto Waterlines attached to side of Cages.  

• Squeeze Back Assembly provided. Squeeze glides on UHMW Plastic Bearing Blocks. 

• Single handed squeeze with thermal neutral perch.

• Squeeze Back wire mesh is ¾” x ¾” wire configuration.

• Single Handed Squeeze with Thermal Neutral Perch.

• Cage Card Holder on sides of Cages, near front.

• Biscuit Retrieval Door provided on lower LH Corner of door area.

• A Telescoping Mid-Section provided. It consists of the Floor from the top cage, the Ceiling from the bottom cage and a telescoping waste pan.  When the mid-section is telescoped to allow vertical pairing, the Half Floor, Half Ceiling and Half Waste Pan slide to the rear of the rack.  No parts to remove or store.  The Telescoping Waste Pan drains to the rear of the rack in either position.  The Rear Floor, Ceiling and Waste Pan are fixed to allow the front half to nest within them.

• Socialization Panels include a Solid, Horizontal Grooming Contact on the RH Side of the cage and a Perforated Divider on LH Side. Center dividers on Cages.  No pairing on sides.

• Unit #58642 has no pairing on ends of Rack.  Unit #58708 does have pairing between Racks.

• Tab on Cage Door to attach/hang mirror/toy on each cage front.

• Bumper with UHMW Plastic on rear of Rack and Handles provided on sides of Rack. 

• All units are bead blasted to a matte finish.