top of page

Print Flyer

One-Over-One Socialization Rack

 Catalog #45876 Right Hand - #45909 Left Hand

  • One-Over-One Configuration that allows easy Horizontal and Vertical Pairing.

  • Approximate overall dimensions of rack are 31-1/2” wide x 37-1/2” deep x 81-1/2” tall.

  • Each cage has min. 6.25 sq. ft. min. floor area based on frame dimensions.

  • Interior height of each cage is approximately 33-3/4” tall.

  • Each rack is supported on Colson Casters with 5” Dia. X 2” wide wheels, sealed SS bearings, #4.05109.925. Front casters have the Tech Lock Brakes # BRK2.

  • All metal components are #304 stainless steel.

  • Heavy Duty Door Latch and lock tab mechanism provided on Hinged Cage Door.

  • Hinged Doors are constructed of ½” diameter perimeter rod with ¼” horizontal rods.

  • A Horizontal Animal Door is provided in each cage door with secure latch & lock tab.

  • Wire Squeeze Back with Single Pull Handle.

  • Squeeze Pull Handle doubles as perch with 4 Linear bars running front to back.

  • Room for water bottle to be used on front of cages.

  • SS Spring Loaded Latches provided on Horizontal Animal Door, Dividers and Pans.

  • Removable welded Wire Feed Box provided on each Cage.

  • Removable Solid Plate provided to put in place of Feed Box when not in use.

  • The primary frame members are fabricated of 1/8” thick SS plate.

  • Solid Back Sheets made of 16 Ga. SS Sheet.

  • Vertical Socialization can be done with Removable mid section components.  It will have a Dry Waste Pan that can be removed.  Wire Floor on Top Cage, Wire Ceiling on Bottom Cage with the ability to insert a Dry Waste Pan between them.

  • Blank I.D. Plate on each Cage front for use with a sharpie.

  • Half floor/ full perimeter rod is provided to insert in mid section when components removed.

  • Ceiling of the Top Cage is 1” x 1” welded wire on the rear half and 1” x 2” on the front.

  • A product I.D. / bar code serial number located each rack.

  • The caster base frame is fabricated of 1-1/2” square SS tube.

  • Full size or Split Removable Dry Waste Pans provided.

  • Removable Floors for Top Cage are 1” x 1” & Bottom Cage is (1” x 2”).

  • Heavy Duty Waterlines are hinged for easy maintenance.  At upper RH rear of Unit.

  • Fixed Wall opposite paired side will be Half Solid and Half Wire.

  • Bumpers provided with UHMW Plastic bumper pads to contact the room wall.

  • Right Hand and Left Handed Units provided. 

  • Provisions for Alcohol Panels provided.

  • Added Notch in each Squeeze Back Panel for Catheter’ d animals.

  • All units are bead blasted to a matte finish.

bottom of page